ZDTM API

This page describes the API one should use to write new test in ZDTM.

Overview

The ZDTM test-suite is the automated suite that launches individual subtests as processes, waits for them to get prepared, then dumps the process(es) started, then restores them and asks to check whether the restored state is what test thinks to be proper. In order to write more subtests developer should use the API declared below. Tests themselves live in one of test/zdtm/live/ sub-directory. The full-cycle suite is the test/zdtm.sh script.

API for test itself

Test body

The test should clearly describe 3 stages:

Preparations

These are actions that test does before the process(es) get checkpointed

Actions

During this the process(es) will be interrupted at arbitrary place and get dumped

Checks

After restore test should verify whether everything is OK or not and report the result

This is achieved by using the following API calls:

test_init(argc, argv)

Just initializes the test subsystem. After this call the preparations stage starts.

test_daemon()

This one says that we finished preparations and ready to get dumped at any time. I.e. -- the actions begin.

test_go()

This routine checks whether the process was dumped and restored or not yet, i.e. the actions stage still goes on.

test_waitsig()

Calling this blocks the task till it's restored. After this the checks stage starts.

pass()

Calling this marks test as PASSED

fail(message)

Calling this would report test failure. The message argument will be written into logs

err(message)

Use this function to mark the test as being unable to work at all.

test_msg(message)

This is for logging.

From the code perspective this looks like this:

int main(int argc, char **argv)
{
	test_init(argc, argv);

	/* Preparations */

	test_daemon();

#if test want to act and get c/r-ed unexpectedly
	while (test_go()) {
		/* Actions go here */
	}
#else test just want to wait for c/r to happen
	/* Actions go here. */

	test_waitsig();
#endif

	/* checks */

	if (test_passed())
		pass();
	else
		fail("Something went wrong");

	return 0;
}

Options

Sometimes a test might need an option to work. E.g. a file or directory to work with or some string to operate on. This can be done by declaring the options.

TEST_OPTION(name, type, description);

The name is some name for the option. The variable of the same name should be declared and the --$name CLI argument would be passed upon test start (this option would be parsed by test_init() call, so nothing more should be done to have the option available).

The type is data type. Currently supported types are string, bool, int, uint, long and ulong.

Description is just arbitrary text.

Building and launching

Then the test should be added into Makefile. There are several sections where simple tests can be added to.

TST_NOFILE

Add your test to this list if the test accepts no options.

TST_FILE

Tests here will be started with the --filename $some_name option. The file will not be created by launcher, test should take care of it itself.

TST_DIR

These will be started with the --dirname $some_name option. The directory will not be created by launcher, test should take care of it itself.

TST

These are tests with custom options. For those one should also declare the starting rule in the Makefile like this

test.pid: test
	$(<D)/$(<F) --pidfile=$@ --outfile=$<.out --OPTIONS-HERE

Checking test works

To make sure test itself works do these steps:

make cleanout  # to clean the directory from old stuff
make $test     # to build the test
make $test.pid # to start the test
make $test.out # to stop the test and ask it for "checking" stage and results

All logs from test, including the pass/fail status would be in the $test.out file.